Noise phenomenon of Variator

   Reason
   1.The abnormal sound of the gear gear wear too much thinner, the gap is too large, the impact of operation; tooth surface meshing is bad, such as repair without replacement of gear pairs. The new, old gear with gear meshing, not correct; tooth surface of metal fatigue spalling or individual tooth damage fracture; spline gear and shaft with loose, axial clearance or gear is too large; shaft bending or bearing looseness caused by gear meshing clearance change
   2.Bearing ring bearing wear serious; the bearing seat and the shaft neck (outer) (hole) with the loose ball bearing; fragmentation or ablation pits
   3.Other reasons such as Variator response in lack of oil, lubricating oil too thin, too thick or bad quality; fall into the foreign body in a transmission; some looseness of the fastening bolt; the odometer flexible shaft or odometer gear ring, fault diagnosis and elimination

WJ series worm-gear speed reducer

   1).Transmission of sound of metal friction sound quality, is short of oil and oil is not good. Should the quality gas and check the oil, replace if necessary
   2).Driving change into a file if the sound clear, namely tooth wear the gear; if the periodic noise, for the individual tooth damage
   3).Gap ring, and the clutch pedal after the noise, generally for a shaft, bearing or gear ring; if any files are sound, more than two shaft bearing rings
   4).All of a sudden crash occurred on the transmission, multi tooth fracture, should promptly remove transmission cover checks, to prevent mechanical damage
   5).Speeds, transmission only in the change into a file when the gear ring, in the premise of the intact, should check the gear is improper collocation, when necessary, should be re assembled a new pair of gears. In addition, also may be the synchronizer gear wear or damage, as the case may be repaired or replaced
   6).The shift gear shock and noise, it might be the clutch can not be separated or clutch pedal travel is not correct, the synchronizer damaged, idle is too large, the gear lever to adjust properly or guide bushings tight. Encounter this kind of situation, first check the clutch can be separated, and then adjust the idle or the shift lever position, tightness inspection guide bushing and isolation bearings.
   Chinabase Machinery is a group of manufacturing facilities, offering one-stop solution for mechanical power transmission，engineering chain，Stainless Steel Chain，Paver Chai，products in China. We can supply a full-range of power transmission products, such as chains, sprockets and plate wheels, pulleys, gearboxes, motors, couplings, gears and racks. Our product range also covers locking assemblies (clamping elements/locking device),Timing Belt Pulleys，taper bushes, QD bushes, bolt-on hubs, torque limiters, shaft collars, motor bases and motor slides,Linear Bearing，chain detachers, chain guides, universal joint, rod ends and yokes. Our products are used in many different industry sector, like in automation engineering, drive engineering, conveyor technology, assembly and handling technology, packaging industries, the beverage, food and medical engineering, pharmaceutical production, and laboratory equipment.