The Install of hydraulic control valve

Chinabase Machinery is a group of manufacturing facilities, offering one-stop solution for mechanical power transmission products in China. 

China couplings manufacturer & exporter, we specialize in: chain couplings, Jaw couplings, flexible couplings, HRC couplings, NM couplings, MH couplings, Pin coupling, Spacer Coupling, timing belt pulleys ，Flange Coupling, Sleeve Coupling, nylon sleeve coupling.

Chinabase is able to offer custom, cost-optimized solutions in accordance with customer drawings - such as ready-to-install machine parts and profiles - in addition to our standard products.

     Hydraulic control valve is a pressure control valve, hydraulic control valve consists of a main valve and attached to the catheter, the pilot valve, needle valve, ball valve and pressure gauge. According to the different purpose, function and location can be turned into a remote control float valve, relief valve, relief valve closed, the flow control valve, relief valve, hydraulic electric control valve, pump control valve. Hydraulic control valves to be installed before the filter, and should facilitate the discharge requirements. This type valve should normally be installed horizontally in the pipeline.

Fluid Couplings

  Install 

Hydraulic control valve should be installed horizontally. The level of installation, the valve cover should be up. Fire water supply system valve valve should have drainage facilities. Automatic sprinkler systems required decompression, the valve should be set before the alarm valve (along the flow direction), with a single matching set alarm valve reducing valve, can not use the valve device; and a plurality of matching set alarm valve reducing valve, pressure reducing valve should be used in equipment factory. Pressure relief valve for water supply projects, should be used for hot water valve.By way of trunk mains cycle (half cycle mode) of the hot water supply engineering, pressure relief valve set requirements should be the same as with the cold water engineering; using riser loop mode (full cycle mode) of the hot water supply engineering, the pressure relief valve setting should be to prevent the water cycle of destruction, the district back pipe should be balanced in the converging point of pressure.