Safe operation of Chain welding machine

     Safe operation

    (1).Material feeding and cutter working table should lower level,the length of the work table can be determined according to thematerial length. Steel processing longer, due to specialassistance, and listen to the operator command, must not be arbitrary sliding.

   (2).Before the start, must inspect the knife should be no cracks,carriage bolts, protective cover firm. Then rotating pulley by hand, check the gear meshing clearance, adjust the cutting clearance.

   (3).After the start, should first idling, check the transmissionparts and bearings in normal operation, before the operation.

   (4).Mechanical did not reach normal speed may not cutting.Cutting must be used in the lower part of the cutter, knife, hold reinforced rapidly into alignment, the operator should stand on the side of the fixed blade cloth reinforced, should prevent the reinforced end out. Prohibit the use of both hands to feed in the blade on both sides hold reinforced leaned.

    (5).Reinforced not shear diameter and strength than steel mechanical nameplate specified and red. A cut a plurality of steel bars, the total cross-sectional area should be in the specified range.

    (6).Shear low alloy steel, should be replaced with a high hardness cutting knife, cutting diameter should be consistent with the provisions of the mechanical nameplate.

    (7).Cut short when the material near the blade, between thehand and blade distance should be kept above 150mm, such asholding end is less than 400mm, application of casing or fixture will suppress short head steel or to.

Spare Parts

    (8).Operation is prohibited directly eliminate near sleepy and debris by hand, reinforced swing around and near the edge of non operating personnel must not stay.

    (9).When it was found that the mechanical operation is not normal, abnormal noise or the cutter deflection, should immediately stop inspection. Repair and maintenance must be shut down, cut off the power supply can be used only for the.

    (10).Hydraulic cutting machine before the work, should check the hydraulic oil level and the rotation direction of the motormeets the requirements. After the start, no-load operation,loosen oil valve, drain the hydraulic cylinder air, can cut tendons.

    (11).Manual hydraulic cutting machine before use, should the oil drain valve in a clockwise direction, after cutting, should immediately counterclockwise unscrewing. During the operation,the hand should be steady cutting machine, and wear insulated gloves.

    (12).After the operation should be cut off the power supply, the elimination of the cutter's debris steel brush, cleaning and lubrication of machine.

      Chinabase is able to offer custom, cost-optimized solutions in accordance with customer drawings - such as ready-to-install machine parts and profiles - in addition to our standard products. Our internal Application Technology department and field staff are happy to provide free advice on custom solutions.

      We can supply a full-range of power transmission products, such as Transmission Chain,Engineering Chain， sprockets and plate wheels, pulleys, gearboxes, motors, Fluid Couplings, gears and racks. Our product range also covers locking assemblies (clamping elements/locking device), taper bushes, QD bushes, bolt-on hubs, torque limiters, shaft collars, motor bases and motor slides, chain detachers, chain guides, universal joint, rod ends and yokes.